Accessories may be added to our beds at any time. They may
be added either during or after initial assembly.
recommend you order your accessories at the same time you order your bed
because there are no additional Shipping Charges for accessory items when
ordered and shipped with a bed. If an accessory item is ordered as a
separate item (without a bed on the order), please contact us first to get the
shipping charge for that item. You may pay the shipping charge at the bottom
of this page. Our beds are
unfinished, sanded and ready for paint or stain. If you need to order
multiple items you may change the quantity in the shopping cart.
Short Bookshelf & Double Bookshelf Headboard
The Short Bookshelf goes the width of the bed underneath the mattress and the Double Bookshelf
Headboard goes above the mattress. Both may
be assembled at either end of the bed. Shelves are Solid Pine.
SB-Short Bookshelf $29
The Solid Headboard may be used as a very nice decorative piece to prevent your
pillow from falling out the back or you may lean up against it when reading in
bed. It can be used on the loft and both levels of the bunk bed and is
attached to the legs. It is Solid Pine and 20" high.
Long Shelf $59.00
The Long Shelf is placed underneath and it
goes across the back of the bed. Solid Pine.
Short • Long • L-Shaped • U-Shaped
We offer multiple desks: Short, Long, L-Shaped & U-Shaped. All are
20" deep, weight capacity 40 lbs. Please contact us if you need a custom
The Short Desk goes the width of the bed may be installed at either end underneath or on the outside end of the bed. It can also be installed at a higher location so you can stand at the desk. Studies show that standing at a desk is
better for you.
We also offer a Desk Shelf which is attached to the short desk and goes the length of the bed across the back of the bed.
The Long Desk goes the full length of the bed across the back and gives you nearly twice the amount of desk space.
The L-Shaped Desk is a combination of the Long and Short Desk. It may be installed either as a Left or Right L.
The U-Shaped Desk is a combination of the Long and Short Desks. It provides the largest desktop area and is perfect for storing books, computers, toys, games and makes a very nice large arts & crafts table for active children.
If you have a lower ceiling and don't have enough headroom space to sit
underneath the loft, you can place the Long Desk at the front of the bed
and place your
chair outside the bed.
If you need a very deep desk, you can use two Long Desks to create a
40" deep desk.
$99 Short Desk
$139 Short Desk and Desk Shelf
$149 Long Desk
$249 L-Shaped Desk
$299 U-Shaped Desk
Clothes Rack $15.00
The Clothes Rack is placed underneath the bed and is 3'
long for the twin size and 4' long for the full and queen
size beds. It comes
completely assembled and goes underneath the mattress between the bed slats. It is
perfect for rooms that don't have a closet for
hanging clothes or for college students needing a more clothes
hanging space. You can have multiple clothes rack on a loft.
Clothes Rack $15
Clothes Racks $30
Clothes Racks $45
Towel Bar $15.00
The Towel Bar
is very popular with college students as dorm rooms and apartments typically
don't have a place
to hang wet towels in the room (and
you definitely don't want to leave your towels in a shared bathroom).
towel bar is 3' long and comes unassembled and may be attached anywhere
on the loft. Typically it is
attached to one of the rungs (either inside or outside), behind the loft or can
hang from one of the slats.
You can have multiple towel bars on a loft.
Towel Bar $15
Towel Bars $30
Towel Bars $45
Safety Rails & Pillow Stop
We follow the Consumer Products Safety Commission (CPSC) Guidelines
for Loft and Bunk Beds
Dorm Use Bed: The CPSC guideline is if the bed is used in a dorm room,
one Safety Rail must be
installed on the front (long) side and must be at least 5" above the top of the
mattress. To save space,
most dorm beds are placed up against a
wall, however, if your bed will not be up against a wall, we recommend a Safety
Rail on the Back Side also. We also have a Pillow Stop available to prevent your pillow from falling out if the headboard is not up against a wall.
Home Use Bed: The CPSC
guideline for home or
apartment beds (for children and adults) is that safety rails are required on all four sides
with a small opening to enter the loft. The top of the safety rail must be
at least 5" above the top of the mattress and there can not be any openings
than 3½" anywhere
above the mattress foundation. We refer to these as a Home Use
Each Safety Rail Set contains 4
safety rails, one for each of the sides. The number of Safety Rail Sets
required is based on the thickness of the mattress. The safety rails also act as a Pillow Stop.
Select Safety Rails - Dorm Use Bed
One Safety Rail on Front (long) Side Only
$39One Safety Rail on Front (long) and Back Side
$19Pillow Stop Only
Select Safety Rails - Home Use Bed
Safety Rails for Mattress up
to 8" Thick
Safety Rails for
Mattress up to 16" Thick (3 Sets)
Select Additional Safety Rail Sets - Home Use Bed
mattress is greater than 16" thick or if you have young (pre-teen) children and would like the safety rails to be more
than 5" above the top of the mattress, we
also offer additional safety
rail sets that go 10" and 15" above the top of the mattress.
You need to first select the
Extra Tall 85" Legs (above) to be able to add
additional sets of safety rails.
Safety Rails to go 10" Above the Mattress
$49 Additional Safety Rails to go 15" Above the
Ladders - Vertical & Angled
Vertical Front Ladder
You need about 2 feet of space at the footboard end of the bed to be able
to climb up using the built-in vertical ladders. If you do not have enough
space, you can use the optional Vertical Front Ladder (long side) to climb
up the front. The ladder is 18" wide.
Front Ladder $59
Ladder & Angled End Ladder
We also have
Angled Ladders may be attached to the Front (long side see left
photo) or at the End (footboard see right photo) of the bed. The angled ladder 2x4 rungs
are positioned flat giving you a larger surface area for climbing up and it is much
easier on your feet. The Angled Ladder comes
pre-assembled and ready to be attached to the loft, is 18" wide and extends out roughly 18" at the bottom.
The weight capacity of the standard Angled Ladder is 200 lbs. We also have Heavy Duty Angled Ladders with wider legs and rungs with a weight capacity of 300 lbs.
Front Ladder $89 (200 lbs. capacity)
End Ladder $89 (200 lbs. capacity)
Angled Front Ladder $129 (300 lbs. capacity)
Angled End Ladder $129 (300 lbs. capacity)
Angled Ladder Handrails
We also have
Handrails for our Angled Ladders. They attach to both sides
Angled Ladder and it makes it much easier climbing up and down.
Angled Ladder Handrail $59
Angled Ladder Hooks
If you need your ladder to be easily removable, we also have Angled Ladder Hooks available. They attach to the back of the Angled Ladder.
Angled Ladder Hooks $19
93" Super Tall Legs
For bedrooms with a ceiling height greater than 9' we also have Super Tall Legs
up to 93" tall. Since the
bed is very tall and top heavy the Corner and Rung Braces (shown below) are
required to stabilize the bed.
The cost is $59 plus a FedEx "Oversize" charge of $60 plus the Corner & Rung Braces for $49 for a
total of $168. FedEx imposes the
oversize charge whenever a package is greater than 85" in length.
Corner & Rung Braces
of our standard beds, Corner and Rung Braces are not required. However if you
have customized it to
make it taller or longer or if
you want additional bracing then Corner and/or Rung Braces may be added.
Also some colleges require all
beds to have Corner & Rung Braces.
The Corner Braces go on the long
sides, Rung Braces go on the rungs at the headboard & footboard ends.
(4) Corner Braces $29
(4) Rung Braces $29
(4) Corner and (4) Rung Braces $49 (save $9)
Loft Conversion Kit
conversion kit allows you to convert one of our existing beds with a new set of
legs and rungs. For
example, you can convert a bunk bed into two loft beds, convert a high
rise to a loft or vice versa. For bunk
beds, you will remove the bottom bunk (rails and slats) and install it on
the legs we provide, you will end up
converting one bunk bed into two loft beds. For your existing high
rise bed, this will allow you to convert it
into a tall loft bed. This is perfect for young children initially
needing a lower loft and moving up to a taller loft
as they get older. During checkout enter into the custom
specifications box the size of your existing bed and